Using a second computer to wake up a sleeping pc. You can set a task to wake up your PC at a specific time, such as when it will turn on the screen and run a program or web page. These packets are able to locate the specific computer you intend to wake using its network card’s MAC address (a media access control address). You can also make it repeat this task later. The only requirement for operating Wake-on-LAN over the internet is that the remote device is connected to a power source and is connected to the internet via a network cable. To set the time and date of the task, go to the Control Panel and type “task scheduler” into the Start menu search bar. Select the option that allows you to wake up your PC on demand. To set the time when the PC will wake up, go into the Settings tab and choose a period of time. If you have a timer that keeps a window open, it may be a good idea to set it for at least a few hours. If it does not wake your PC when you open it, try disabling the program in Task Scheduler and restarting your computer. If the program still doesn’t wake the computer, then you can try configuring it in a new user account. If there is a proxy or NAT so that the computer isn't directly exposed to the public Internet (doesn't have an IP of its own but. This will reset all of your power plan settings and remove any custom ones that you may have created. If it's directly connected to the Internet and has a public IP you can use that to send the magic packet for waking the computer up. Using TeamViewer, you can remotely wake up a sleeping PC in the same way as you would do if you were at home. By enabling the Wake-on-LAN feature, you don’t need port-forwarding, a remote IP address, or any third-party tools to wake up a PC from a remote location. First, you must enable Wake-on-LAN in your PC’s BIOS or device manager. Once the feature is enabled, go to Extras and click on the Configure button next to the Wake-on-LAN option. To use the Wake-on-LAN feature, you must be connected to the Internet through your TeamViewer account. Once the account has been created, you can go to the Settings menu on the TeamViewer client and click on “Setup.” Once the application has started, you should see a prompt asking you to specify the public address. You can also use your TeamViewer ID or DNS name. You must also have a UDP port for waking up a sleeping PC. Using a second computer to wake up a sleeping pc If you want to wake up a sleeping PC, you can use a second computer.
0 Comments
Leave a Reply. |